X -10 Remote Timer Control Instructions
To set time:
• Set master switch (upper left hand corner) to “set clock”.
• Use “time +-” to set correct time.
• Set master switch back to “run”.
To reprogram time on and off:
1. Set master switch to “review”.
2. Press toggle switch that you wish to change (if on time for #1 is to be changed,
press #1 on now).
3. The display will show the present setting, If this is the time you wish to change,
press, “clear” now.
4. While in the review mode, clear any other on or off settings you desire, then press
all toggles to make sure that the ones that were cleared show 0.00.
5. Set the master switch to “program” and use the “+ - time” button to reach the new
on or off time.
6. Now press the appropriate toggle (#1 on in our example) to program the new
time. Do this for each time you wish to reprogram.
7. Set the master switch back to “review” and press each toggle on or off to make
sure the new program was accepted.
8. Set the master switch on “run” and you are done.